DPF Cleaning Service
-
Receiving & Inspection
Upon arrival, your filter is thoroughly inspected and logged into our tracking system to ensure complete service documentation.
-
Initial Testing
Each filter is weighed and pressure tested to establish baseline performance data. These results are recorded and included in the final service report.
-
Initial Pneumatic Cleaning
The filter undergoes an initial pneumatic cleaning process to remove loose soot and particulate matter accumulated within the filter.
-
Pressurized Hydro Cleaning
Our proprietary Hydro Cleaning process utilizes pressurized water to safely and effectively clean the DPF substrate. This cleaning method is recognized and approved by Cummins for restoring filter performance.
-
Thermal Regeneration
Every filter is subjected to an 8-hour thermal regeneration cycle designed to convert remaining soot and contaminants into ash for easier removal.
-
Final Pneumatic Cleaning
Following thermal regeneration, the filter receives a second pneumatic cleaning to remove any remaining ash and soot released during the thermal regeneration process.
-
Final Testing
The filter is weighed and pressure tested again to verify cleaning effectiveness. The collected data allows us to measure the amount of soot removed and confirm that airflow has been restored to industry standards.
-
Final Inspection & Repairs
A comprehensive final inspection is performed to ensure the filter meets quality standards. Requested repairs, such as sensor bung replacement or repair, are completed, and the filter is thoroughly cleaned externally to ensure a clean and efficient reinstallation process.
Request your Service.
